Renault Duster 2007 Manual page 565

POWER ASSISTED STEERING
Power-assisted steering pump: Removal - Refitting
K4M, and AIR CONDITIONING
a Disconnect the power-assisted steering pump high
pressure pipe.
a Fit plugs to the pipe and power-assisted steering
pump openings to prevent impurities from entering.
a Remove:
- the bolts (4) from the power-assisted steering
pump on the multifunction support,
- the power-assisted steering pump towards the mo-
tor-driven fan assembly.
REFITTING
I - REFITTING PREPARATION OPERATION
a
WARNING
Do not remove the blanking plugs from each
component until the last moment.
Also, do not remove the components from their
packaging until they are to be fitted to the vehi-
cle.
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit:
- the power-assisted steering pump,
- the power-assisted steering pump bolts on the mul-
tifunction support.
a Remove the plugs from the pipe openings.
a Refit:
- the high pressure pipe union on the power-assisted
steering pump,
- the high pressure pipe bolt on the cylinder block.
a Torque tighten:
Note:
Tighten to torque first the two bolts on the acces-
sories belt side, then the bolts on the other side.
- the power-assisted steering pump bolts on the
multifunction support (21 N.m),
- the high pressure union on the power-assisted
steering pump (21 N.m),
- the high pressure pipe bolt on the cylinder
block (21 N.m).
a Clip the pipe connecting the « dehydrator reservoir
and the expansion valve » on the motor-driven fan
assembly.
a Connect the inlet hose on the power-assisted steer-
ing pump.
a Refit the hydraulic inlet hose clip on the power-as-
sisted steering pump using the.
a Remove the hose clamps (Ms. 583) from the hy-
draulic inlet and outlet pipes of the power-assisted
steering pump.
36B-8
36B