Renault Duster 2007 Manual page 157

TOP AND FRONT OF ENGINE
Camshaft: Removal - Refitting
K9K
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Mark the position of the camshaft bearings.
a Remove:
- the camshaft bearing bolts (5) ,
- the camshaft bearings,
- the camshaft,
- the timing end camshaft seal.
REFITTING
I - REFITTING PREPARATION OPERATION
a parts always to be replaced: Camshaft seal on
timing end.
WARNING
To ensure proper sealing, the gasket surfaces
must be clean, dry and not greasy (avoid any fin-
ger marks).
WARNING
Do not scrape the joint faces of the aluminium,
113563
any damage caused to the joint face will result in
a risk of leaks.
a Use GREY ABRASIVE PADS (see Vehicle: Parts
and consumables for the repair) (04B, Consum-
ables - Products) to clean the bearing faces of the
camshaft bearings.
a Use SURFACE CLEANER (see Vehicle: Parts
and consumables for the repair) (04B, Consuma-
bles - Products) to clean and degrease:
- the bearing faces of the camshaft bearings on the
cylinder head,
- the bearing faces of the camshaft bearings on the
camshaft bearings.
113565
a
WARNING
Applying excess sealant could cause it to be
squeezed out when parts are tightened. A mix-
ture of sealant and fluid could damage certain
components (engine, radiator, etc.).
11A-54
11A
20064-1