Tyres: Removal - Refitting - Renault Duster 2007 Manual

REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
- the wheel in question (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, page 35A-1) ,
- the balance weights,
- the valve mechanism.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Detach:
- the bead from the outside of the tyre, starting with
the side opposite the valve,
- the bead from the inside of the tyre.
WHEELS AND TYRES

Tyres: Removal - Refitting

18884
a Position the tyre lever approximately 15 cm from the
valve on the outside of the wheel rim in order to re-
move the exterior bead from the tyre.
a Remove the exterior bead of the tyre, finishing at the
valve.
a Position the tyre lever approximately 15 cm from the
valve on the outside of the wheel rim in order to re-
move the bead from inside the tyre.
a Remove the interior bead of the tyre, finishing at the
valve.
REFITTING
I - REFITTING PREPARATION OPERATION
a Lubricate the two tyre beads correctly using the
TYRE PASTE (see Vehicle: Parts and consum-
ables for the repair) (04B, Consumables - Prod-
ucts).
II - REFITTING OPERATION FOR PART
CONCERNED
a Engage the lower tyre bead approximately 15 cm af-
ter the valve.
a Finish fitting the tyre at the valve.
a Fit the exterior bead approximately 15 cm after the
valve using the tyre lever.
a Inflate the tyre to 3.5 bar to press the tyre beads
against the wheel rim.
35A-9
35A
18885