Renault Duster 2007 Manual page 1058

UCH
Vdiag No.: 09
ET485
STATUS DEFINITION
NOTES
Check the connection and condition of the hazard warning lights switch connector, component code 125.
If the connector is faulty and there is a repair procedure (see Technical Note 6015A (Renault) or Technical Note
9804A (Dacia), Electrical wiring repair, Wiring: Precautions for repair), repair the connector, otherwise replace
the wiring.
Check for earth on connection MAN of component 125.
If the connection is faulty and if there is a repair procedure (see Technical Note 6015A (Renault) or Technical
Note 9804A (Dacia), Electrical wiring repair, Wiring: Precautions for repair), repair the wiring, otherwise
replace it.
Check the operation of the hazard warning lights control.
Check the continuity between the following connections MAN and 64Q of component 125:
If the connections are faulty and if there is a repair procedure (see Technical Note 6015A (Renault) or Technical
Note 9804A (Dacia), Electrical wiring repair, Wiring: Precautions for repair), repair the wiring, otherwise
replace it.
AFTER REPAIR
UCH_V09_ET485
MR-453-X79-80D000$080.mif
V1
LIGHTING
Fault finding – Interpretation of statuses
HAZARD WARNING LIGHTS SIGNAL
PRESENT when the hazard warning lights are switched on.
ABSENT if there is no request for the hazard warning lights.
There must be no present or stored faults.
Activate the hazard warning lights switch using the button.
The status should be PRESENT.
Special note:
Use the Wiring Diagrams Technical Note for DUSTER.
Carry out another fault finding check on the system.
Deal with any other faults.
Clear the stored faults.
80D-19
80D