Renault Duster 2007 Manual page 431

Front right-hand driveshaft gaiter, gearbox side: Removal - Refitting
JR5
a Position the gaiter lip into the groove of the yoke
sleeve.
Note:
Check that the gaiter lip is correctly positioned in
the groove of the driveshaft.
a Fit:
- the small securing clip on the driveshaft gaiter,
- the big securing clip on the driveshaft gaiter.
CAILLEAU « click » clips
a Tighten the small clip (11) and the big clip (12) until
they click, using the tool.
DRIVESHAFTS
2910
29A-14
OETIKER clips
a Tighten the small clip (13) and the big clip (14) using
the tool.
Position 1 - Pre-tightening and positioning of the
clip
a Put the linkage (15) in the lower position, and close
the pliers fully. The pre-tightened clip slides onto the
gaiter and can be positioned.
29A
96048
2911