Renault Duster 2007 Manual page 521

Rear suspension spring: Removal - Refitting
4X2 TRANSMISSION
a Remove the spring (4) with its lower mounting by re-
moving the component jack.
Note:
If the upper mounting is unclipped, replace it.
REFITTING
I - REFITTING PREPARATION OPERATION
a Always replace the rear shock absorber lower bolt.
II - REFITTING OPERATION
a Refit:
- the lower mounting on the rear axle (positioning the
guide correctly),
- the spring with its upper mounting in the marked lo-
cation, starting at the top.
a Bring the component jack into contact, using a
shim, under the spring cup.
a Compress the rear axle so that the shock absorber
lower bolt can be refitted.
a Refit the shock absorber lower bolt.
a Torque tighten the shock absorber lower bolt (162
N.m).
a Remove the tool component jack.
a Refit the wheel speed sensor wiring.
REAR AXLE COMPONENTS
108924
III - FINAL OPERATION
a Refit the rear wheel (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, page 35A-1) .
a Repeat these operations on the opposite side.
33A-15
33A