Renault Duster 2007 Manual page 186

Inlet distributor: Removal - Refitting
K4M
a
WARNING
Do not scrape the joint faces of the aluminium,
any damage caused to the joint face will result in
a risk of leaks.
WARNING
T o ensure proper sealing, the gasket surfaces
must be clean, dry and not greasy (avoid any fin-
ger marks).
Use SURFACE CLEANER (see Vehicle: Parts
and consumables for the repair) (04B, Consum-
ables - Products) to clean and degrease:
- the housing of each inlet distributor seal if reused,
- the joint face of the injector holder shim.
a Fit new seals to the inlet distributor.
a When replacing the inlet distributor, refit:
- the air temperature sensor,
- the inlet distributor pressure sensor.
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit:
- the inlet distributor,
- the inlet distributor mounting bolts.
a Torque tighten in order the intake distributor
mounting bolts (9 N.m).
FUEL MIXTURE
116653
12A-13
III - FINAL OPERATION
a Refit the throttle valve equipped with a new seal (see
12A, Fuel mixture, Throttle valve: Removal - Re-
fitting, page 12A-11) .
a Clip the wiring onto the inlet distributor.
a Connect:
- the coil connectors,
- the air inlet pressure sensor connector,
- the air temperature sensor connector.
a Position the accelerator cable on the inlet distributor
and on the throttle valve.
12A