Engine Wiring: Removal - Refitting - Renault Duster 2007 Manual

Engine wiring: Removal - Refitting

K4M
Equipment required
indelible pencil
Diagnostic tool
Tightening torquesm
manual gearbox earth
cable bolt
earth cable nuts
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and opera-
tion recommendations before carrying out any
repair:
- (See Wiring: Precautions for repair) (88A, Wir-
ing),
- (see Vehicle: Precautions for repair) (01D,
Mechanical introduction).
IMPORTANT
To prevent any accidental triggering during an oper-
ation on or near to a passive safety component,
apply the procedure for deactivating the safety sys-
tems (see 88C, Air bag and Pretensioners, Air-
bag and pretensioners: Precautions for the
repair, page 88C-3) (88C, Airbag and pretension-
ers)
IMPORTANT
Never handle the pyrotechnic systems (pretension-
ers or airbags) near to a source of heat or naked
flame - they may be triggered.
WARNING
To prevent damage to the wiring harness when
refitting, observe the original routing.
WIRING HARNESS
24 N.m
8 N.m
88A-5
WARNING
To prevent any damage to the connectors, consult
the disconnection procedures (see Connectors:
Disconnection and reconnection) (Technical
Note 6015A, 88A, Wiring).
Note:
For information on instrument connectors (see
Visu-Schéma).
(A) Symbol for an earth
(B) Symbol for a mounting (clip,
clamp, etc.)
(C) Symbol for a female connector
(connection of 2 wires)
(D) Symbol for a male connector
(connection of 2 wires)
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Switch off the ignition.
a Disconnect the battery (see 80A, Battery, Battery:
Removal - Refitting, page 80A-2) (80A, Battery).
88A
144441