Timing Belt: Removal - Refitting - Renault Duster 2007 Manual

TOP AND FRONT OF ENGINE

Timing belt: Removal - Refitting

K4M
Tightening torquesm
timing fixed roller bolt
new crankshaft acces-
sories pulley bolt
timing tension wheel nut
lower timing cover bolts
nut of each camshaft
sprocket
TDC pin plug
upper timing cover bolts
upper timing cover nuts
flywheel end lifting eye
bolts
IMPORTANT
Wear cut-resistant gloves during the operation.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove:
- the air inlet duct,
- the air resonator (see 12A, Fuel mixture, Air res-
onator: Removal - Refitting, page 12A-2) ,
- the front right-hand wheel (see Wheel: Removal -
Refitting) (35A, Wheels and tyres),
- the accessories belt (see 11A, Top and front of
engine, Accessories belt: Removal - Refitting,
page 11A-2) ,
- the crankshaft accessories pulley (see 11A, Top
and front of engine, Crankshaft accessories
pulley: Removal - Refitting, page 11A-10) ,
- the right-hand suspended engine mounting (see
19D, Engine mounting, Right-hand suspended
engine mounting: Removal - Refitting, page
19D-4) .
50 N.m
40 N.m + 145˚
± ± ± ± 15˚
27 N.m
12 N.m
30 N.m + 84˚ ± ± ± ±
4˚
20 N.m
46 N.m
46 N.m
10 N.m
a Remove:
11A-17
- the upper timing cover bolts (1) ,
- the upper timing cover,
- the lower timing cover bolts (2) ,
- the lower timing cover.
11A
14487