Left-Hand Suspended Engine Mounting: Removal - Refitting - Renault Duster 2007 Manual

Left-hand suspended engine mounting: Removal - Refitting

Special tooling required
Mot. 1453 Engine anchorage support
with multiple adjustments and
retaining straps.
Tightening torquesm
bolts mounting the left-
hand suspended mount-
ing on the gearbox
bolt of the power-
assisted steering pipe
on the left-hand sus-
pended mounting
stud on the gearbox
support
left-hand rubber pad
mounting bolts on the
body
rubber pad nuts on the
left-hand suspended
mounting
nut of the gearbox sup-
port on the rubber pad
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
- the air inlet sleeve,
- the battery (see Battery: Removal - Refitting)
(80A, Battery),
- the battery tray,
- the injection computer (see 17B, Petrol injection,
Petrol injection computer: Removal - Refitting,
page 17B-7) ,
- the engine undertray.
ENGINE MOUNTING
62 N.m
21 N.m
180 N.m
21 N.m
105 N.m
62 N.m
19D-2
a Fit the engine support tool (Mot. 1453) with the re-
taining belt, taking the flywheel end lifting eye as an
anchoring point.
a Mark the position of the left-hand suspended engine
mounting on the body.
II - REMOVAL OPERATION
a Remove the nut (1) from the gearbox support on the
rubber pad.
a Strike the gearbox stud with a copper hammer to
separate the engine and gearbox assembly from the
body.
a Remove:
- the nuts (2) from the rubber pad,
- the rubber pad,
19D
107930
102112