Front Bumper Wiring: Removal - Refitting - Renault Duster 2007 Manual

Front bumper wiring: Removal - Refitting

IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and opera-
tion recommendations before carrying out any
repair (see 88A, Wiring harness, Wiring: Precau-
tions for the repair, page 88A-3) .
WARNING
To avoid damaging the connectors, consult the dis-
connection procedures (see Connector: Discon-
nection and reconnection) (Technical Note
6015A, 88A, Wiring).
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Switch off the ignition.
a Disconnect the battery (see 80A, Battery, Battery:
Removal - Refitting, page 80A-2) .
a Remove the front bumper (see Front bumper as-
sembly: Exploded view) (55A, Exterior protection).
II - REMOVAL OPERATION
a
WARNING
T o prevent any risk of noise, premature wear,
short circuits, etc. after the refitting operation,
mark the wiring routing and how to connect the
connectors.
a Disconnect the front fog light connectors (1) .
WIRING HARNESS
145081
88A-4
a Unclip the front bumper wiring at (2) .
WARNING
To prevent any damage during the removal oper-
ation, check that the wiring is free from its mount-
ings (retaining clip, plastic clip, adhesive tape,
connector, etc.).
a Remove the front bumper wiring.
REFITTING
I - REFITTING PREPARATION OPERATION
a If replacing with more complete wiring, immobilise
the unused connectors (see Connector: Sealing
and locking) (Technical Note 6015A, 88A, Wiring).
II - REFITTING OPERATION
a Proceed in the reverse order to removal.
a Connect the battery (see 80A, Battery, Battery: Re-
moval - Refitting, page 80A-2) .
III - CHECKING AFTER REPAIR
a Switch on the ignition.
a Check the operation of all front bumper electrical
components.
88A