Renault Duster 2007 Manual page 400

Manual gearbox: Removal - Refitting
K9K, and JR5
a Remove:
- the gearbox lower bolts (21) ,
- the gearbox stud nuts (22) ,
- the gearbox.
REFITTING
I - REFITTING PREPARATION OPERATION
a Check for leaks from the input shaft, replace the
guide tube if necessary (see 21A, Manual gearbox,
Input shaft lip seal: Removal - Refitting, page
21A-25) .
a Always replace:
- the differential outlet seals,
- the clutch thrust bearing.
a Remove:
- the differential output seals (see 21A, Manual
gearbox, Differential output seal: Removal - Re-
fitting, page 21A-2) .
- the clutch thrust bearing (see 20A, Clutch, Clutch
thrust bearing: Removal - Refitting, page 20A-6)
.
a Refit:
- new differential output seals (see 21A, Manual
gearbox, Differential output seal: Removal - Re-
fitting, page 21A-2) .
MANUAL GEARBOX
107936
21A-9
- a new clutch thrust bearing (see 20A, Clutch,
Clutch thrust bearing: Removal - Refitting, page
20A-6) .
a
WARNING
To avoid damaging the slave cylinder, do not coat
the gearbox output shaft with grease.
WARNING
To avoid damaging the clutch slave cylinder, do
not coat the gearbox output shaft with grease.
a
Note:
If a stud is loosened during this operation, coat
the stud with HIGH RESISTANCE THREAD-
LOCK (see Vehicle: Parts and consumables
for the repair) . .
Torque tighten:
- the stud on the engine (8 N.m),
- the stud on the gearbox (8 N.m).
II - REFITTING OPERATION
a Check that the engine - gearbox centring rings are in
place and correctly positioned.
a Couple the gearbox to the engine.
a Refit the gearbox stud nuts.
a Torque tighten the gearbox stud nuts (44 N.m).
a Refit:
- the gearbox lower bolts,
- the gearbox upper bolts.
a Torque tighten the upper and lower gearbox bolts
(44 N.m).
a Remove the component jack.
a Refit the left-hand suspended engine mounting (see
Left-hand suspended engine mounting: Remov-
al - Refitting) .
a Remove the engine support tool (Mot. 1453).
21A