Camshaft Seal, Timing End: Removal - Refitting - Renault Duster 2007 Manual

TOP AND FRONT OF ENGINE

Camshaft seal, timing end: Removal - Refitting

K4M
Tightening torquesm
inlet camshaft hub nut
exhaust camshaft hub
nut
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove:
- the front right-hand wheel (see Wheel: Removal -
Refitting) (35A, Wheels and tyres),
- the air filter unit (see 12A, Fuel mixture, Air filter
unit: Removal - Refitting, page 12A-6) ,
- the throttle valve (see 12A, Fuel mixture, Throttle
valve: Removal - Refitting, page 12A-11) ,
- the air inlet distributor (see 12A, Fuel mixture, In-
let distributor: Removal - Refitting, page 12A-
12) ,
- the right-hand suspended engine mounting (see
19D, Engine mounting, Right-hand suspended
engine mounting: Removal - Refitting, page
19D-4) ,
- the accessories belt (see 11A, Top and front of
engine, Accessories belt: Removal - Refitting,
page 11A-2) ,
- the timing belt (see 11A, Top and front of engine,
Timing belt: Removal - Refitting, page 11A-17) .
30 N.m + 84˚ ± ± ± ±
4˚
30 N.m + 84˚ ± ± ± ±
4˚
a Fit the locking tool (1) on the camshaft pulleys.
a Remove:
11A-56
- the inlet camshaft pulley nut (2) ,
- the exhaust camshaft pulley nut (3) ,
- the,
- the inlet camshaft pulley,
- the exhaust camshaft pulley.
11A
135235