Front Driveshaft Hub Carrier: Removal - Refitting - Renault Duster 2007 Manual

FRONT AXLE COMPONENTS

Front driveshaft hub carrier: Removal - Refitting

Tightening torquesm
shock absorber base
bolts
nut or bolt of the lower
ball joint
track rod end nut
hub nut
brake calliper mounting
bolts
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and opera-
tion recommendations before carrying out any
repair:
- (see 31A, Front axle components, Front axle
components: Precautions for the repair, page
31A-1) ,
- (see Vehicle: Precautions for the repair) (01D,
Mechanical introduction).
WARNING
In order not to damage the brake hose:
- do not tension the hose,
- do not twist the hose,
- check that there is no contact with the surrounding
components.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Unlock the steering column.
a Remove the front wheel on the side concerned (see
35A, Wheels and tyres, Wheel: Removal - Refit-
ting, page 35A-1) .
II - REMOVAL OPERATION
ANTI-LOCK BRAKING SYSTEM
105 N.m
a Remove the wheel speed sensor (depending on the
vehicle equipment) (see 38C, Anti-lock braking
system, Front wheel speed sensor: Removal -
62 N.m
Refitting, page 38C-7) .
37 N.m
280 N.m
105 N.m
31A-27
31A