Coolant Pump: Removal - Refitting - Renault Duster 2007 Manual

Coolant pump: Removal - Refitting

K9K, and 796
Tightening torquesm
bolts of the coolant
pump
inner timing cover bolts
alternator bolts
IMPORTANT
Wear leaktight gloves (Nitrile type) for this opera-
tion.
IMPORTANT
Wear heat protective gloves during the operation.
IMPORTANT
The circuits are designed to be pressurised, so be
careful at high temperatures (risk of serious burns).
Do not remove the cap from the expansion bottle
while the engine is hot.
Take care when carrying out a repair under the bon-
net, as the radiator fan(s) may start to operate with-
out warning.
Do not open the bleed screw(s) with the engine run-
ning.
WARNING
Prepare for the flow of fluid, and protect the sur-
rounding components.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove:
- the engine cover,
- the engine undertray bolts,
COOLING
- the engine undertray.
a Remove the front bumper (see Front bumper: Re-
moval - Refitting) (55A, Exterior protection).
10 N.m
a Drain the cooling system (see 19A, Cooling, Cool-
ing system: Draining - Refilling, page 19A-6) .
a Remove:
9 N.m
- the accessories belt (see 11A, Top and front of
21 N.m
- the timing belt (see 11A, Top and front of engine,
a Disconnect the electrical connections from the alter-
nator.
a Remove the alternator upper bolt (1) .
a Loosen the alternator lower bolt.
a Tilt the alternator forward.
19A-13
engine, Accessories belt: Removal - Refitting,
page 11A-2) ,
Timing belt: Removal - Refitting, page 11A-17) .
19A
102267