Rigid Brake Pipe: Removal - Refitting - Renault Duster 2007 Manual

Rigid brake pipe: Removal - Refitting

Equipment required
pedal press
Tightening torquesm
rigid brake pipe unions
on the brake cylinders
rigid brake pipe unions
on the rear brake hoses
The pipes have a rigid and a flexible section.
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and opera-
tion recommendations before carrying out any
repair (see 33A, Rear axle components, Rear
axle components: Precautions for the repair,
page 33A-1) .
WARNING
Prepare for the flow of fluid, and protect the sur-
rounding components.
WARNING
To avoid damaging the wheel speed sensor cable:
- Do not tension the cable,
- Do not twist the cable,
- Check that there is no contact with the surround-
ing components,
- Do not use tools that may damage the cable.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Fit the pedal press to the brake pedal to limit the
amount of brake fluid running out.
REAR AXLE COMPONENTS
14 N.m
14 N.m
II - REMOVAL OPERATION
1 -Rear left-hand rigid brake pipe
a Unscrew:
- the rigid brake pipe union on the rear axle (1) ,
- the rigid brake pipe union on the rear brake cylinder
(2) .
a Unclip the rear axle rigid brake pipe.
a Remove the rear left-hand rigid brake pipe.
2 - Rear right-hand rigid brake pipe
a Unscrew:
- the rigid brake pipe union on the rear axle brake
hose (3) ,
- the rigid brake pipe union on the rear brake cylinder
(4) .
a Unclip the rear axle rigid brake pipe.
a Remove the rear right-hand rigid brake pipe.
33A-10
33A
108927
108928