Renault Duster 2007 Manual page 931

Steering column switch assembly: Removal - Refitting
a
Note:
Before removing the assembly, it is essential to
mark the position of the rotary switch by immobil-
ising the rotary switch rotor with adhesive tape.
a Partially remove the steering column switch assem-
bly to disconnect its connectors.
a Remove the steering wheel control assembly.
REFITTING
I - REFITTING PREPARATION OPERATION
a The steering wheel bolt must always be replaced.
a Ensure that the wheels are still straight.
a Check that the switch tape is correctly centred (2.5
rotations on each side).
Note:
If the rotary switch is being replaced, the new
part is supplied ready centred with an adhesive
label which will tear off when the wheel is turned
for the first time (wheels must be straight when
fitting).
II - REFITTING OPERATION FOR PART
CONCERNED
a Engage the steering assembly on the steering col-
umn.
CONTROL - SIGNALS
108743
84A-3
a Connect the various connectors.
a Remove the adhesive tape.
Note:
Continue refitting and do not tighten bolt until the
two half-shells are refitted so that the stalks can
be aligned with the instrument panel and dash-
board. This operation is made easier by a cut-out
section giving access to the bolt in the lower half-
shell.
a Clip on:
- the upper half-shell,
- the lower half-shell.
a Refit the two lower bolts.
a Position the stalks in alignment with the instrument
panel and dashboard.
a Tighten the bolts (3) securing the rotary switch.
III - FINAL OPERATION
a Refit:
- the steering wheel (see Steering wheel: Removal
- Refitting) (36A, Steering),
- the driver's front airbag (see 88C, Air bag and Pre-
tensioners, Driver's frontal airbag: Removal -
Refitting, page 88C-6) .
a Connect the battery (see 80A, Battery, Battery: Re-
moval - Refitting, page 80A-2) .
a Unlock the airbag computer (see Fault finding - Re-
placement of components) (88C, Airbag and pre-
tensioners).
a Carry out a function test on the steering column
switch assembly.
IV - CHECKING AFTER REPAIR
a Switch on the ignition.
a Check the operation of the rotary switch:
- turn the steering wheel to the left until it stops,
- turn the steering wheel to the right until it stops,
- bring the steering wheel back to the central posi-
tion,
- check that there are no faults on the instrument
panel.
84A