Renault Duster 2007 Manual page 564

POWER ASSISTED STEERING
Power-assisted steering pump: Removal - Refitting
K4M, and AIR CONDITIONING
Special tooling required
Ms. 583 Pipe clamps.
Tightening torquesm
power-assisted steering
pump bolts on the multi-
function support
high pressure union on
t h e p ower-assisted
steering pump
high pressure pipe bolt
on the cylinder block
injector rail protector
nuts
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see 02A, Lift-
ing equipment, Vehicle: Towing and lifting).
a Remove:
- the accessories belt (see 11A, Top and front of
engine, Accessories belt: Removal - Refitting),
- the injector rail protector.
WARNING
Protect the alternator from escaping power
assisted steering fluid.
a Drain the power-assisted steering fluid reservoir us-
ing a syringe.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Fit hose clamps (Ms. 583) on the hydraulic inlet and
outlet pipes of the power-assisted steering pump.
21 N.m
21 N.m
21 N.m
21 N.m
a Remove the hydraulic inlet hose clip (1) on the pow-
er-assisted steering pump using the tool.
a Disconnect the inlet hose (2) .
a Disconnect the pipe connecting the « dehydrator
reservoir and the expansion valve » on the motor-
driven fan assembly.
a Remove:
- the high pressure pipe bolt on the cylinder block,
- the power-assisted steering pump high pressure
pipe union (3) .
36B-7
36B
116658
116646