Renault Duster 2007 Manual page 995

Engine wiring: Removal - Refitting
K9K, and 796
a Disconnect all the connectors.
a Unclip the engine wiring where indicated.
a
Note:
Before removing the earth terminal, mark its
position using a indelible pencil by drawing a
line on the earth terminal and on the gearbox
casing.
When reassembling, improper positioning of the
earth terminal on the gearbox casing could result
in damage to the earth terminal or earth wiring.
a Remove the earth terminals.
WARNING
T o prevent any damage during the removal oper-
ation, check that the wiring is free from its mount-
ings (retaining clip, plastic clip, adhesive tape,
connector, etc.).
a Remove the engine wiring.
WIRING HARNESS
88A-23
REFITTING
I - REFITTING PREPARATION OPERATION
If replacing the engine wiring
a Refit the fuses.
a If replacing with a complete wiring harness, lock the
unused connectors (see Connectors: Sealing and
locking) (Technical Note 6015A, 88A, Wiring).
II - REFITTING OPERATION
a Proceed in the reverse order to removal.
Note:
Refit the earth terminal, aligning the indelible
marks on the gearbox casing.
When reassembling, improper positioning of the
earth terminal on the gearbox casing could result
in damage to the earth terminal or ear th wiring.
a Torque tighten:
- the manual gearbox earth cable bolt (24 N.m),
88A
145242