Installing The Mx240 Normal-Capacity Fan Tray - Juniper MX240 Hardware Manual

Figure 83: Removing the Fan Tray
SEE ALSO

Installing the MX240 Normal-Capacity Fan Tray | 283

Preventing Electrostatic Discharge Damage to an MX240 Router | 467
Installing the MX240 Normal-Capacity Fan Tray
To install the fan tray (see
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Grasp the fan tray handle, and insert it straight into the chassis. Note the correct orientation by the
this side up label on the top surface of the fan tray.
3. Tighten the captive screws on the fan tray faceplate to secure it in the chassis.
Figure 84 on page 284):
283