Installing An M10I Fan Tray; Figure 33: Removing A Fan Tray - Juniper M10i Hardware Manual

M10i Multiservice Edge Router Hardware Guide

Installing an M10i Fan Tray

102
All manuals and user guides at all-guides.com
CAUTION: To avoid injury, keep tools and your fingers away from the fans
as you slide the fan tray out of the chassis. The fans might still be spinning.
Place one hand under the fan tray to support it and slide the tray completely out of
4.
the chassis after the fans stop spinning.

Figure 33: Removing a Fan Tray

To install a fan tray (see Figure 34 on page 103):
CAUTION: For proper airflow, the primary fan tray should be installed in slot
, on the left rear of the chassis. The redundant fan tray should be installed
1
in slot on the right.
0
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Grasp the handle on the faceplate of the fan tray with one hand and place the other
2.
hand under the unit to support it. Orient the fan tray so that the thumbscrew is at the
top of the tray.
Slide the tray into the slot.
3.
Tighten the thumbscrew to seat the fan tray firmly in the chassis.
4.
Copyright © 2010, Juniper Networks, Inc.