Removing And Installing Protective Cover - Skoda Kodiaq 2017 Workshop Manual

Kodiaq 2017 ➤ , Kodiaq 2019 ➤
Brake systems - Edition 11.2018
13 - Dust cap
2.2 Removing and installing protective cov‐
er
Special tools and workshop equipment required
♦ Piston jig - T10145-
♦ Assembly tool - T10146-
♦ Plastic wedge - 3409-
Removing
Only the protective cover always has to be replaced.
Note
If the protective cover is replaced, the brake caliper does not have
to be removed or the brake hose unscrewed.
• The piston is pushed back.
• Handbrake control motor has been removed.
NOTICE
♦ When the piston and compressor nut are removed, the
thread is destroyed.
♦ Never completely unscrew the compressor nuts and piston!
– Unscrew the piston in -direction of arrow- by maximum of
20 mm -a-.
– Use the disassembly wedge - 3409- to remove the protective
cover from the brake caliper.
Installing
Note
Use only methylated spirits for cleaning the brake.
– The piston surfaces and brake caliper must be cleaned with
spirit and then left to dry.
86
Rep. gr.47 - Brakes - hydraulics