Activating A Default Model On A Telephone With A Character Display - Nortel Meridian 1 Planning And Installation Manual

Appendix B – Additional information for installations in Germany
Activating a default model on a telephone with a character
display
Note: If you replace the handset before you complete the prompt
sequence below, the installation fails. If you make an error and want to
restart the procedure, you can replace the handset.
1 Change display language to German.
2 Plug the telephone set into the jack and wait 20 seconds before you
lift the handset. If you do not receive dial tone, replace the handset
and wait another 10 seconds before lifting the handset again. Repeat
this procedure until you receive dial tone.
If successful, the character display shows either "MODEL?(XX)" (if the
telephone relocation feature is not in use) or "ZUG O.NEUES
TELEFON?(XX)" (if the telephone relocation feature is in use). "XX"
represents the default model for the telephone that you are activating.
Note: If you do not see the prompt "MODEL?(XX)" after lifting the
handset, disconnect the telephone from the wall jack, wait five seconds,
and insert the telephone into the jack again. The telephone now shows
"MODEL?(XX)" when you lift the handset.
Note: The system uses the 20 second time interval to determine if the set
is new or if it is being relocated using the Modular Telephone Relocation
feature.
Option 11C Mini Planning and Installation Guide
Page 417 of 590