Nortel Meridian 1 Planning And Installation Manual page 225

Chapter 12 — Installing the circuit cards
Trunk Data Block
Use Overlay 14 to configure each of the trunk units on the NTAG04AA
CO/DID trunk card.
LD 14 - Route Data Block
Prompt Response
REQ NEW
TYPE COT
TN CC UU
CDEN (8D)
XTRK XCOT
(see note)
SIGL ALS
PPID 07
CLS DTN, (DIP)
Note: These prompts are required only for the first unit defined on each
NTAG04AA card.
Comments
Define a new trunk unit
Central Office Trunk
Terminal number of the unit:
Card, Unit
Card density is 8D (default)
Type is IPE COT
ALS signaling
PPM country Identification
Digitone signaling, (Digipulse)
Option 11C Mini Planning and Installation Guide
Page 205 of 590