Nt5K83Db E&M Tie Trunk Card - Nortel Meridian 1 Planning And Installation Manual

Hide thumbs Also See for Meridian 1:

Table of Contents

Switch settings

There are four switch settings on the E&M TIE trunk card, one for each trunk

Procedure 23

NT5K83CB E&M TIE trunk card installation

Set the switch settings on the card, as shown in Table 25 on

Insert the card into the selected card slot and lock it in position.

Connect the trunk units to the cross-connect terminal by tip and

ring leads (Refer to the Tables in "Chapter 18 — Connecting the

trunks" on page 313).

Configure the card in software (LDs 16 and 14).

—————————— End of Procedure ——————————

When the NT5K83CB card is installed and power is applied to it, a self-test

is performed on the card. The red LED on the card's faceplate flashes three

times, then remains continuously lit until the card is enabled in software. If

the self-test fails, the LED remains lit after the card is enabled.

NT5K83DB E&M TIE trunk card

The NT5K83DB card provides four trunks which can function as the

4-wire E&M (Type I and II)

4-wire E&M BPO (Type V)

2-wire E&M (Type I)

2-wire E&M BPO (Type V)

Chapter 12 — Installing the circuit cards

Option 11C Mini

Page 157 of 590

Planning and Installation Guide

Option 11c mini