Installing Software In A New System; Summary Of Steps - Nortel Meridian 1 Planning And Installation Manual

Chapter 16 — Starting the Option 11C Mini and installing software
Archived database
The Software Installation Program allows the archiving of various databases
which can be used later at Option 11C Mini sites. It allows multiple databases
to be configured off-site and then installed ready-to-use at customer sites.
Remote restored database
A database can be remotely restored using the Overlay 143 CCBR remote
restore command.
Backed up Database
The Backed up Database option allows the copy on the backup flash drive to
be installed. It is provided to recover a customer database if the customer
database on the primary flash drive becomes corrupted.

Installing software in a new system

Before beginning the software installation process, complete Step 1 through
Step 19 in "Summary of installation procedures" on page 72. You must
install the security device on the MSC card, and you must have the Keycode
Data Sheet available.

Summary of steps

The Software Installation steps are summarized in the following list:
Note: Off-site programming of databases is subject to all security
keycode restrictions. The off-site system must either use the Security
Device that will be installed in the Option 11C Mini at the customer site,
or must have its own keycodes for the feature set used.
Note: In the menus and screens, there are references to Option 11 and
Option 11E. These references do not apply to the Option 11C Mini.
• Setting the system time and date
• Selecting the New System Installation menu
• Selecting Feature Set and packages
• Selecting a database
• Selecting Incremental Software Management (ISM)
parameters
• Validating keycodes
• Loading the software
Option 11C Mini Planning and Installation Guide
Page 275 of 590