Maintenance And Administration Terminals; On-Site Access; Remote Access - Nortel Meridian 1 Planning And Installation Manual

Maintenance and administration terminals

On-site access

Remote access

Chapter 3 — System and site requirements
Refer to "Terminal setup" on page 261 for set-up information for Option 11C
Mini recommended terminals.
A Modem Eliminator (NULL Modem without hardware handshaking)
A0601397 F-F converter or A0601396 M-F may be required to interface the
TTY to the system.
The following describes the minimum requirements for a TTY device:
Without Meridian Mail
The minimum requirement is a VT100 compatible device when Meridian
Mail is not installed, and will not be installed in the future.
With Meridian Mail
With Meridian Mail, use a VT220 compatible device.
Equip each system with an M2616 or M2008 telephone with display. These
telephones act as maintenance telephones.
You can use many different TTY terminals to access the Option 11C Mini.
However, a VT220 terminal is recommended as an on-site terminal. You can
use this terminal to perform service changes, maintenance and diagnostic
functions, and Meridian Mail administration activities.
Although you can use several types of modems to access the system, a 2400
baud auto-answer modem is the recommended modem. A 1200 baud modem
is the minimum requirement. You can use the modem to perform service
changes, maintenance and diagnostic functions, and Meridian Mail
administration activities from a remote location.
Note: You can perform additional maintenance functions through
remote access on the Option 11C Mini. For additional information, refer
to the Customer Configuration Backup and Restore Guide
(553-3011-330).
Option 11C Mini Planning and Installation Guide
Page 47 of 590