Ntak03 Tds/Dtr Card - Nortel Meridian 1 Planning And Installation Manual

Table 22
Switch settings (Ports 2 and 3)
Port
SDI
SDI
Table 23
Jumper settings
Port
Port 0
Port 1
Port 2
Port 3
2 Insert the card in its assigned slot.
You can install the NTAK02 SDI/DCH card in slots 1 to 3 of the Main
Chassis.
3 Connect an NTAK19FB four port cable (or an NE-A25-B cable)
from the corresponding connector at the back of the chassis. If
you use an NE-A25-B cable, terminate this cable at the
cross-connect terminal. Because the NTAK19FB cable is
equipped with connectors, it does not require termination at the
cross-connect terminal.

NTAK03 TDS/DTR card

The NTDK97 MSC card provides the NTAK03 TDS/DTR card functionality.
However, the TDS/DTR card can exist with the MSC card if you want to
access additional TDS/DTR units. You must program these functions in the
software overlays.
Chapter 12 — Installing the circuit cards
Port
2 3
DCH
DPNSS
— ESDI
Jumper Strap
location for DTE
J10 C - B
J7 C - B
J6 C - B
J5 C - B
J4 C - B
J3 C - B
Option 11C Mini
SW
1-3
OFF
OFF
ON
Strap Jumper
for DCE location
B - A
B - A J9
B - A J8
B - A
B - A J2
B - A J1
Planning and Installation Guide
Page 139 of 590
SW
1-4
OFF
ON
ON
RS422 RS232
C - B B - A
C - B B - A
C - B B - A
C - B B - A