Chapter 12 - Installing The Circuit Cards - Nortel Meridian 1 Planning And Installation Manual

Chapter 12 — Installing the circuit cards
This chapter describes how and where to install circuit cards used in the
Option 11C Mini system. This chapter is divided into the following main
sections:
• "Circuit cards required for the Option 11C Mini" on page 129. This
section describes the installation of the NTDK97 MSC card and the
NTDK16 48-port Digital Line Card. These cards are required for the
Option 11C Mini system.
• "Optional circuit cards" on page 134. This section describes the circuit
cards that are optional to the Option 11C Mini system.
• "Circuit cards used in Europe" on page 147. This section describes
optional circuit cards that are supported in Europe.
Refer to "Card slot assignments" on page 59 for additional information on
where to place circuit cards.
Refer to the Intelligent Peripheral Equipment Circuit Card Supplements for
full descriptions of country-specific IPE cards and their installation
procedures.
Always handle circuit cards with caution to avoid damage caused by
static electricity. Always store circuit cards that are not in use in an
antistatic bag or the original packaging
Wear an antistatic wrist strap, such as the one shown in Figure 39,
when handling circuit cards. Static electricity can damage circuit card
components.
CAUTION
Option 11C Mini Planning and Installation Guide
Page 125 of 590