Nortel Meridian 1 Planning And Installation Manual page 297

Page 276 of 590
Chapter 16 — Starting the Option 11C Mini and installing software
Procedure 62
Installing software
1
2
3
553-3021-209 Standard 1.00
Make sure the MSC card is in CPU slot (slot 00) of the Main
Chassis.
For first-time installations, software is installed from the MSC card.
Software is loaded on the MSC card when it arrives at the customer
site.
Observe the terminal screen.
One of two messages will appear and the software installation
proceeds accordingly. If the message is:
INSERT SOFTWARE DELIVERY CARD
Go to Step 3.
OR if the following is displayed:
SOFTWARE INSTALLATION PROGRAM
proceed with Step 4 on page 277.
Skip this step unless the Software Delivery (PCMCIA) card is being
used to install the software.
If you have not already done so, install the Software Delivery card
in Slot A in the socket in the faceplate of the MSC card.
Note: You do not have to disconnect the power from the system
before you install the Software Delivery card in Slot A.
See Figure 66.
Insert the card in slot A in the PCMCIA socket located in the faceplate
of the NTDK97 MSC card. Carefully press on the Software Delivery
card until it is firmly seated. See Figure 66.
July 1999