Chapter 6 - Getting Started Installing The Option 11C Mini; Tools Checklist - Nortel Meridian 1 Planning And Installation Manual

Chapter 6 — Getting started installing the
Option 11C Mini

Tools checklist

This chapter contains tools and readiness checklists. Before beginning the
installation, make sure you have all the tools necessary to install the Option
11C Mini. Make sure you have checked all site requirements, received all
equipment, and have prepared an equipment layout plan and a card slot
assignment plan
This chapter also provides a high-level summary of installation procedures
for the Option 11C Mini. Where applicable, the summary contains references
to the chapter that describes the procedure in more detail.
To install the system correctly, make sure that the following tools are
available before you begin to assemble the components:
different types of screwdrivers
a tape measure
a level
pliers such as side cutters and longnose pliers
an ECOS 1023 POW-R-MATE or similar type test meter
appropriate cable terminating tools
a drill for drilling lead holes for screws
Option 11C Mini Planning and Installation Guide
Page 71 of 590