Activating A Selected Model Trunk - Nortel Meridian 1 Planning And Installation Manual
Hide thumbs
Also See for Meridian 1:
- Manual (1121 pages) ,
- Planning, installation and operating instructions (556 pages) ,
- Administration and maintenance (507 pages)
Table of Contents
Advertisement
Page 424 of 590
Activating a selected model trunk
553-3021-209
Standard 1.00
Appendix B – Additional information for installations in Germany
8
Terminate the sequence by hanging up the telephone receiver.
OR
Repeat the sequence by going through the steps again.
By entering "#" when the procedure repeats, you accept the next TN and
are prompted for the model type.
By entering "#" again, you accept the previously accepted model.
Note: The model used for the first trunk activated in the sequence will
be the default for all subsequent trunks until the telephone is hung up
unless you manually enter a new trunk model number.
1
Lift the handset of the administration telephone.
2
Enter the administration Flexible Feature Code "*41" to access the
administration menu.
The prompt "PASSWORT?" appears.
3
Enter the default password "6891".
You hear special dial tone and the prompt
"EINGABE?"
appears on the top line of the character display.
The second line of the character display reads "1 LEITUNG
ANMELDEN".
4
Select "1 LEITUNG ANMELDEN" by entering the number "1".
The prompt "BÜNDEL-KENNZAHL" appears.
5
Enter the access code of the configured trunk route to which you
want to add the trunk and press the pound key (#).
The prompt
"TERMINAL-NR?"
asks you to enter a TN from one of the installed trunk cards.
If you do not enter a valid route number, "TERMINAL-NR?" does not
appear and the screen remains the same. If the type of trunk card does not
match the route, the prompt "BÜNDEL-KENNZAHL" appears again,
and you hear overflow tone.
July 1999
Advertisement
Table of Contents
