Activating A Default Model With A Character Display - Nortel Meridian 1 Planning And Installation Manual

Activating a default model with a character display

Procedure 68
Activating the telephone
1 Plug the telephone set into the jack and wait 20 seconds before
you lift the handset. If you do not receive a dial tone, replace the
handset and wait another 10 seconds before lifting the handset
again. Repeat this procedure until you receive dial tone.
If successful, the character display shows either "MODEL? X" (if the
telephone relocation feature is not in use) or "RELOC OR MODEL? X"
(if the telephone relocation feature is in use). "X" represents the default
model for the telephone that you are activating.
Note: If you do not see the prompt "MODEL X" after lifting the
handset, disconnect the telephone from the wall jack. Wait five
seconds, and insert the telephone into the jack again. The telephone
now shows "MODEL X" when you lift the handset.
Note: The system requires the 20 second time interval to determine if
the set is new or if it is being relocated using the Modular Telephone
Relocation feature.
2 Press the pound key (#) to select the default model.
The character display shows "OK, EXTENSION? XXXX". "XXXX"
represents the default extension number for this telephone type.
Chapter 17 — Connecting the telephones
Option 11C Mini
Page 305 of 590
Planning and Installation Guide