Nortel Meridian 1 Planning And Installation Manual page 203

Chapter 12 — Installing the circuit cards
LD 16 - Configure an outgoing E3W COT route.
Prompt Response
ICOG OGT
...
CNTL YES
- TIMR ICF 0
- TIMR OGF 0
- TIMR EOD 13952
- TIMR DSI 11904
- TIMR DDL 0
- TIMR GTO 2944
...
NEDC ETH
FEDC ETH
CDPC (NO)
...
NATL NO
...
LEC 0-9999999
ADDG 0-(8)-9
CAC 0-(3)-9
ANDN 0-9999999
RDNL 0-(4)-7
Description
Outgoing trunk.
Change control or timers.
Set the incoming flash timer to 0 in milliseconds.
Validation will be done by 3WT firmware.
Set the outgoing flash timer to 0 in milliseconds.
Validation will be done by 3WT firmware.
End of dial timer, default value.
Disconnect supervision timer.
Delay Dial Timer not needed.
Outgoing guard timer.
Near End Disconnect Control Either end control.
Far End Disconnect Control Either end control.
Meridian 1 is not the controlling party on
incoming calls.
North American Toll scheme.
Local Exchange Code.
Additional digit.
Route ANI category.
Route ANI DN.
Route DN Length for ANI.This is printed for
DPNSS1, MCDN, and QSIG routes only.
Option 11C Mini Planning and Installation Guide
Page 183 of 590