Ntak02 Sdi/Dch Card - Nortel Meridian 1 Planning And Installation Manual

Page 138 of 590

NTAK02 SDI/DCH card

553-3021-209 Standard 1.00
Chapter 12 — Installing the circuit cards
The NTDK97 MSC card includes the functionality of the NTAK02 card.
However, if you require additional resources, you can use the NTAK02 card
with the NTDK97 card. Before inserting the NTAK02 SDI/DCH card into its
slot, you must set the switches and attach the jumper plugs.
Note: Install this circuit card in the Main Chassis only.
The NTAK02 SDI/DCH switches allow you to configure the four SDI ports
as a combination of the following:
• SDI
• ESDI
• DCH/DPNSS
The NTAK02 SDI/DCH card uses jumper plugs to configure the
RS232/RS422 interfaces as one of the following:
• DTE
• DCE
Procedure 14
NTAK02 circuit card installation
1 Set the switches and jumper plugs for the NTAK02 SDI/DCH card
according to Tables 21 to 23.
Table 21
Switch settings (Ports 0 and 1)
Port
0
SDI
SDI
—
July 1999
Port
1
DCH
DPNSS
ESDI
SW SW
1-1 1-2
OFF OFF
OFF ON
ON ON