Installing The Chassis On A Wall In A Vertical Position; Items Required - Nortel Meridian 1 Planning And Installation Manual

Page 94 of 590
Chapter 9 — Installing the chassis

Installing the chassis on a wall in a vertical position

Items required

To install the chassis on a wall in a vertical position, you require the following
items:
•
•
•
•
•
•
The NTTK08 bracket kit contains all of the above items, with the exception
of the equipment layout plan and the plywood.
Refer to Figure 21 on page 95 for guidelines on how to position the system
components.
553-3021-209 Standard 1.00
equipment layout plan
chassis bracket
wall bracket
five 1 in. #12 wood screws provided in the bracket kit (or other
appropriate fasteners) to hold the wall brackets and chassis on the wall
four #8 - 32 machine screws, used to attach the chassis brackets to the
wall
one 3/4 in. (20 mm) piece of plywood fastened to the wall
An Option 11C Mini chassis with circuit cards installed weighs 30 lb.
(13.5 kg). Make sure that you fasten the equipment securely to the
wall. Use fasteners designed to hold securely to the type of surface
chosen to support the equipment. When using 3/4 in. (20 mm)
plywood or other similar material as a backboard, make sure to attach
backboard directly to the wall studs in a minimum of six locations.
July 1999
CAUTION