Nortel Meridian 1 Planning And Installation Manual page 172

Page 152 of 590
553-3021-209 Standard 1.00
Chapter 12 — Installing the circuit cards
LD 16 - Route Data Block
Prompt Response
REQ NEW
TYPE RDB
CUST 0-99
ROUT 0-127
TKTP TIE, (RAN),
(PAG), (MUS)
RTYP
REP 1-15
POST DIS, ATT
STRT IMM, DDL
ACOD XXXXXXX
ICOG ICT, OGT, IAO
NEDC ETH, (ORG)
FEDC ETH, (ORG)
July 1999
Comments
Define a new Route Data Block
Enter customer number
Enter route number
Trunk type is TIE, (Recorded
Announcement), (Paging), or (Music)
RAN Type
Number of repetitions (RAN)
After maximum repetitions (RAN):
Disconnect (DIS), or Route to
Attendant (ATT)
Connect call to recording immediately
(IMM), or at start of recording (DDL)
Trunk route access code
Incoming trunk (ICT), Outgoing trunk
(OGT, or both (IAO)
Near end disconnect control from
either side, or (originating) end
Far end disconnect control from either
end, or (originating) end