Start-Up Procedures - Nortel Meridian 1 Planning And Installation Manual

Page 270 of 590
Chapter 16 — Starting the Option 11C Mini and installing software

Start-up procedures

Procedure 60
Start-up procedure for a first-time system installation, using the MSC
card
1
2
Figure 65
Power connector on the back of the chassis
553-3021-209 Standard 1.00
Test the power outlet. Make sure that the correct voltage of power is
present before you plug the power cord into the outlet. The source
must match the label on the back of the chassis.
Connect the power cord from the power connector on the back of the
chassis to an AC power source. See Table 65.
Power cord
connector
July 1999