Nt5K02Da Flexible Analog Line Card - Nortel Meridian 1 Planning And Installation Manual

Page 166 of 590

NT5K02DA Flexible analog line card

553-3021-209 Standard 1.00
Chapter 12 — Installing the circuit cards
LD 14 - Route Data Block
STRI IMM, WNK, DDL
STRO IMM, WNK, DDL Outgoing start immediate, Wink,
SUPN YES, (NO)
CLS DTN, (DIP)
Note: This prompt is required only for the first unit defined on each
NT5K83HA card.
Self-test
When the NT5K83HA card is installed and power is applied to it, a self-test
is performed on the card. The red LED on the card's faceplate flashes three
times, then remains continuously lit until the card is enabled in software. If
the self-test fails, the LED remains lit after the card is enabled.
Switch settings
There are no option switches on the NT5K02DA card. Configure all settings
in software.
Procedure 28
NT5K02DA Flexible analog line card installation
1 Insert the card in its allocated card slot.
2 Connect the line card units to the cross-connect terminal and
telephone by tip and ring leads.
3 Configure the telephone lines in software (LD 10).
—————————— End of Procedure ——————————
Self-test
The faceplate of the NT5K96DA is equipped with a red LED. The LED lights
when all of the assigned units on the circuit card are disabled.
July 1999
Incoming start Immediate, Wink,
Delayed dial
Delayed Dial
Answer and disconnect
supervision
Digitone, (Dialpulse)