Safety Instructions When Installing Telephone Equipment; Safety Instructions When Using Telephone Equipment - Nortel Meridian 1 Planning And Installation Manual
Hide thumbs
Also See for Meridian 1:
- Manual (1121 pages) ,
- Planning, installation and operating instructions (556 pages) ,
- Administration and maintenance (507 pages)
Table of Contents
Advertisement
Page 80 of 590
Chapter 7 — Important safety instructions
Safety instructions when installing telephone equipment
Safety instructions when using telephone equipment
553-3021-209
Standard 1.00
The following are safety instructions for installing telephone equipment:
•
Never install telephone wiring during a lightning storm.
•
Never install telephone jacks in wet locations unless the jack is
specifically designed for wet locations.
•
Never touch uninsulated telephone wires or terminals unless the
telephone line has been disconnected at the network interface.
•
Use caution when installing or modifying telephone lines.
Always follow basic safety precautions when using telephone equipment.
Following these safety precautions reduces the risk of fire, electric shock, and
injury to persons, including the following:
•
Follow all warnings and instructions marked on the product.
•
Before you clean a telephone, remove the plug from the wall outlet. Do
not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.
•
Do not use the telephone near water (for example, near a bath tub, wash
bowl, kitchen sink, laundry tub, in a wet basement, or near a swimming
pool).
•
Do not place the telephone on a table, cart, or stand that is not stable. The
product may fall, causing serious damage to the product.
•
Slots and openings in the cabinet and the back or bottom of the telephone
are for ventilation. These ventilation slots protect the telephone from
overheating. Never block or cover these openings.
Never block the openings on a telephone by placing the product on a bed,
sofa, rug, or other similar surface. Never place the product near or over a
radiator or heat register. Do not place the product in a built-in
installation, unless proper ventilation is provided.
•
Only operate the product from the type of power source indicated on the
marking label. If you are not sure of the type of power supply, check with
your distributor.
July 1999
Advertisement
Table of Contents
