Software Installation Program - Nortel Meridian 1 Planning And Installation Manual

Chapter 16 — Starting the Option 11C Mini and installing software
3
4
5
Procedure 61
Start-up procedure for a previously installed system
1
2
3
4
5

Software Installation Program

The Software Installation Program provides a menu-driven method of
selecting from the different options of installing, modifying, or upgrading the
following:
•
•
•
•
The flash ROM stores information about the selections. This information is
in the form of a list of instructions for the program to follow when it runs.
Observe the TTY or terminal screen. The TTY must be connected to
TTY port 0.
When you have completed the software installation (see "Installing
software in a new system" on page 275), observe the screen again.
Perform an EDD using Overlay 43.
After the system is loaded, a menu-driven program called the
"Software Installation Program" is automatically called up.
—————————— End of Procedure ——————————
Test the power outlet. Make sure that the correct voltage of power is
present before you plug the power cord into the outlet. The source
must match the label on the back of the chassis.
Connect the system to an AC power source.
Observe the TTY or terminal screen.
Messages appear on the TTY or the terminal screen. When the
message "INIXXX" appears, the system is in operation.
If required, set the system time and date using Overlay 2.
Perform an EDD using Overlay 43.
—————————— End of Procedure ——————————
software
customer data
feature set
Incremental Software Management (ISM) parameters
Option 11C Mini Planning and Installation Guide
Page 271 of 590