Nt5K72Aa E&M Tie Trunk Card - Nortel Meridian 1 Planning And Installation Manual

Page 150 of 590
NT5K72AA E&M TIE trunk card
553-3021-209 Standard 1.00
Chapter 12 — Installing the circuit cards
Trunk Data Block
Use Overlay 14 to configure each of the trunk units on the NT5K50AA E&M
trunk card. In the Overlay tables, default values are in parenthesis.
LD 14 Route Data Block
Prompt Response
REQ NEW
TYPE TIE, RAN, PAG
TN CC UU
XTRK XFEM
(see note)
SIGL EM4, EAM,
EMTY TY1, (TY2)
STRI IMM, WNK, DDL Incoming start Immediate, Wink,
STRO IMM, WNK, DDL Outgoing start immediate, Wink,
SUPN YES, (NO)
CLS DTN, (DIP)
Note: These prompts are required only for the first unit defined on each
NT5K50AA card.
Self-test
When the NT5K50AA card is installed and power is applied to it, a self-test
is performed on the card. The red LED on the NT5K50AA faceplate flashes
three times, then remains continuously lit until the card is enabled in software.
If the self-test fails, the LED remains lit after the card is enabled.
This trunk card provides four trunks which can function as 4-Wire E&M
(Type 1 and 2), RAN, PAG, and MUS.
July 1999
Comments
Define a new trunk unit
Trunk type TIE, (Recorded
announcement), (Voice paging)
Terminal number of the unit:
Card, Unit
Type is IPE XFEM
4 wire E&M, 2-wire E&M,
Type 1signaling, (Type 2)
Also use TY1 for Type V or BPO
Delayed dial
Delayed Dial
Answer and disconnect supervision
Digitone, (Dialpulse)