Nortel Meridian 1 Planning And Installation Manual page 181

Chapter 12 — Installing the circuit cards
—————————— End of Procedure ——————————
Note: For Type V signaling to work, set the TYP prompt to TY1 or to
BPO, if available, in LD 14.
LD 16 - Route Data Block
Prompt Response
REQ NEW
TYPE RDB
CUST 0-99
ROUT 0-511
TKTP TIE, RAN, PAG
ICOG IAO
ACOD XX
Use Overlay 14 to configure each of the trunk units on the NT5K83FA card.
In the Overlay tables, the default values are in parenthesis.
LD 14 - Route Data Block
Prompt Response
REQ NEW
TYPE TIE, RAN, PAG
TN CC UU
XTRK XFEM
(see note)
SIGL EM4, EAM, WR4 4 wire E&M, 2-wire E&M,
EMTY TY1, (TY2)
STRI IMM, WNK, DDL
STRO IMM, WNK, DDL Outgoing start immediate, Wink,
Comments
Define a new Route Data Block
Enter customer number
Enter route number
Define trunk type as TIE, Recorded
announcement or Paging
Incoming and Outgoing trunk
XX=Trunk route access code
Comments
Define a new trunk unit
Trunk type TIE, (Recorded
announcement), (Voice paging)
Terminal number of the unit:
Card, Unit
Type is IPE XFEM
CEPT L1 AC15 signaling
Type 1 signaling, (Type 2)
Incoming start Immediate, Wink,
Delayed dial
Delayed Dial
Option 11C Mini Planning and Installation Guide
Page 161 of 590