Activating A Default Model On A Telephone Without A Character Display - Nortel Meridian 1 Planning And Installation Manual

Appendix B – Additional information for installations in Germany
Activating a default model on a telephone without a character
display
1 Plug the telephone set into the jack and wait 20 seconds before you
lift the handset. If you do not receive dial tone, replace the handset
and wait another 10 seconds before lifting the handset again. Repeat
this procedure until you receive dial tone.
Note: The system uses the 20 second time interval to determine if the set
is new or if it is being relocated using the Modular Telephone Relocation
feature.
2 Press the pound key "#" to select the default model.
3 Press the pound key again to select the default extension number.
You hear relocation tone.
OR
If the extension number is already in use by another telephone, you hear
special dial tone.
To accept the default extension number press the pound key.
To select a new extension number, manually enter an extension
number and press the pound key.
If the extension number is not available for use, you hear overflow tone.
This occurs when you select an extension number manually or when
extension numbers are entered for additional keys. A default extension
number will not be offered if it is not available. Repeat step 3 and enter
a new extension number manually.
Note: If other keys require secondary extension numbers, you are
prompted until you enter all of the required extension numbers for the
model. These extension numbers cannot be defaulted. You are prompted
for each additional extension number special dial tone. When you are
programming an extension number, the lamp associated with that
number on the telephone is lit.
Option 11C Mini Planning and Installation Guide
Page 419 of 590