Nortel Meridian 1 Planning And Installation Manual page 175

Chapter 12 — Installing the circuit cards
Trunk Data Block
Use Overlay 14 to configure each of the trunk units on the NT5K83AB card.
In the Overlay tables, default values are in parenthesis.
LD 14 - Route Data Block
Prompt Response
REQ NEW
TYPE TIE, (RAN),
(PAG)
TN CC UU
XTRK XFEM
(see note)
SIGL EM4
EMTY TY1, (TY2)
STRI IMM, (WNK),
(DDL)
STRO IMM, (WNK),
(DDL)
SUPN YES, (NO)
CLS TRC, (NTC)
Note: These prompts are required only for the first unit defined on each
NT5K83AB card.
Comments
Define a new trunk unit
Trunk type TIE, (Recorded
announcement), (Voice paging)
Terminal number of the unit in Option
11 format:
CC=card number
UU=unit number
Type is IPE XFEM
4 wire E&M speech
Type 1 signaling, (Type 2)
Incoming start Immediate, (Wink),
(Delayed dial)
Outgoing start immediate, (Wink),
(Delayed Dial)
Answer and disconnect supervision
Attenuation pads in, (out)
Option 11C Mini Planning and Installation Guide
Page 155 of 590