Ntck24Aa Central Office Trunk Card - Nortel Meridian 1 Planning And Installation Manual

NTCK24AA Central Office trunk card

Switch settings
The NTCK24AA card does not have any option switches. Configure all
settings in software.
Procedure 46
Installation of the NTCK24AA Central Office trunk card
1 Insert the card into the selected card slot and lock it in position.
2 Connect the trunk units to the cross-connect terminal by tip and
ring leads (Refer to "Chapter 18 — Connecting the trunks" on
page 313).
3 Configure the card in software (LDs 16 and 14).
—————————— End of Procedure ——————————
LD 16 - Route Data Block
Prompt
REQ
TYPE
CUST
ROUT
TKTP
ICOG
ACOD
CNTL
TIMER
DTD
2DT
XTDT
Chapter 12 — Installing the circuit cards
Response Comments
NEW
RDB Define a new Route Data Block
0-99 Enter customer number
0-511 Enter route number
COT Define the trunk type as Central Office
IAO Incoming and Outgoing trunk
XXXXXXX Trunk route access code
YES Change a trunk timer
RGV 384 Ring Validation Timer = 384 ms
YES(NO) Dial tone detector performed / not
performed on this route If Yes, answer
the following 2DT and XTDT prompts.
YES
(0)-7 Extended tone detector table number
programmed in Overlay 97
(Enter 0 if the table has not already
been programmed in LD 97)
Option 11C Mini
Page 211 of 590
Planning and Installation Guide