Konica Minolta REGIUS 110 Service Manual page 43

12
10 11
10:
Justifier Guide
11:
Justifier Sensor
12: Justifier HP Sensor
13:
Justifier Standard
14:
Justifier Standard Sensor
15
15: Push Plate Unit
54
Justifier guide will move toward the justifier
standard, pressing the cassette to the justifier
standard block.
Justifier motor will rotate, according to the cassette size
14
from the barcode, moving the justifier guide to the
justifier standard side.
13
55
Justifier guide will move to the slightly opened
position.
Justifier motor will rotate, moving the justifier guide
slightly (approximately 3 mm) to the home position side.
Slightly opened position:
56
Receiver will lower to the second falling position.
Receiver will lower to the second falling position by
rotating the receiver motor for appropriate pulses
(depends on the cassette size) after the justifier guide
completes its move.
Second falling position:
57
The justifier guide will move toward the justifier
standard and the cassette is fixed between the
justifier guide and the justifier standard block.
Justifier motor will rotate, moving the justifier guide
slightly (approximately 3 mm) toward the justifier
standard side.
58
Push plate unit will move to the press down
position. The shutter is close at the same time.
The transporter motor will rotate and move the push
plate unit to the press down position.
The shutter is closed by rotating the shutter motor.
Chapter 2 Before the Repair
A position slightly moved from
cassette fixing position toward the
home position to unfix the cassette.
Position of the lock/lock release
mechanism and open/close lock
of the cassette will match.
2-23