Konica Minolta REGIUS 110 Service Manual page 112

Chapter 4 Confirming Operation Using Service Tool
Sequence
type*
A B
*: Sequence type
A: Using the cassette
B: Not using the cassette
Sensor Status for Each Step
Shows the status of the sensors after each step has completed its operation when the step action is
performed with the cassette. (Areas boxed are the sensors that have changed its status from the previous
step.)
After Initialization
SeqID=50: Detect cassette
"Cassette Insertion S2" stays OFF when the cassette is 15 x 30 cm.
4-10
SeqID
60 Move the push plate unit to the read position
61 Slightly lower the receiver
62 Read
63 Erase
64 Move the push plate unit to the press down position
65 Lock
66 Move the push plate unit to the passing point of the home position
67 Move the push plate unit to the home position & shutter open
68 Slightly release the cassette fixation by the justifier guide
69 Move the receiver to the first falling position
70 Move the justifier guide to the home position
71 Move the receiver to the home position
72 Detect the eject of cassette
73 Shutter close
Operation