Konica Minolta REGIUS 110 Service Manual page 72

Chapter 3 Troubleshooting
Error code
S E
06302
06303 06318 06333 Cassette during the
References for response method
•
See "2.5.2 Receiver unit (Page 2-12)"
motor, the justifier standard sensor, and the justifier sensor.
•
See "2.5.8 Framework (Page 2-19)"
•
See "6.3 Adjustment of Justifier Motor (Page 6-6)"
the amount of justification.
•
See "5.4.13 Replacing the Justifier Belt (Page 5-62)"
gear unit for the justifier motor.
•
See "5.4.4 Replacing the Justifier Standard Sensor (Page 5-44)"
justifier standard sensor.
•
See "5.4.2 Replacing the Justifier Sensor (Page 5-41)"
sensor.
•
See "5.10.2 Replacing the MDU (Page 5-116)"
3-18
Description of the error
I
Cassette during the startup
(justifier sensor)
Justifier sensor or justifier
standard sensor was ON during
the initialization by PowerON.
initialization (justifier sensor)
Justifier sensor or justifier
standard sensor was ON during
the initialization after closing the
second front door.
for the position of the receiver, the justifier guide, the justifier
for the position of the MDU.
Response
(References to replacement methods are
listed at the end of the table.)
1. Confirm for foreign object inside the
equipment, and remove it if there is
any.
2. Confirm following and replace the
faulty parts.
•
Justifier standard sensor
•
Sensor wire:
JP44 ~ MCN3 (MDU)
•
Justifier sensor
•
Sensor wire: JP40 ~ JJ18/JP18 ~
MCN3 (MDU)
•
MDU
Confirm following and replace the faulty parts.
•
Justifier standard sensor
•
Sensor wire: JP44 ~ MCN3 (MDU)
•
Justifier sensor
•
Sensor wire:
JP40 ~ JJ18/JP18 ~ MCN3 (MDU)
•
MDU
for the confirmation and adjustment methods for
for the method to mount the pulley and the
for the procedure to replace the
for the procedure to replace the justifier
for the procedure to replace the MDU.