Second Front
Back Side
CN2
CN4
CN5
CN1
CN9
CN2
JP61
Second Front Side
First Front Back Side
Chapter 5 Disassembly and Assembly
4
Connect the cables to the circuit board on the
optical unit.
•
LMC
•
CN1 (ACN1: cable)
•
CN2 (ACN2: cable)
•
CN4 (ACN4: cable)
•
CN5 (ACN5: cable)
•
CN9 (ACN9: cable)
•
LMD
•
CN2 (LMCN2: cable)
•
Eraser unit junction cable
•
JJ61 (JP61: cable)
5
Install the snap ties and other parts.
•
Snap ties at 3 locations
•
Tie fixtures at 3 locations
6
Release the simple fixing lock and move the
optical unit to the second front side.
Push the optical unit slightly towards the
back when pulling up the knob. Fixing shaft
Important
might move down, and get locked again if
the optical unit is at its hithermost position.
7
In the second front side, fix the optical unit using
a simple fixing lock.
8
Temporarily fix the setscrews on the second front
side.
•
2 hex/Phillips-head screws (M4 x 12)
9
Release the simple fixing lock and move the
optical unit to the second front back side.
10
In the second front back side, fix the optical unit
using a simple fixing lock.
11
Install the setscrews on the first front back side.
•
2 hex/Phillips-head screws (M4 x 12)
5-15